Ceiling Fan Projects
This service covers new fan installation at a suitable location, replacement of an existing fan and fan-specific issues such as wobble, noise, speed problems or failed controls. The fan can also include a light kit, remote or compatible smart control.
Exhaust fans are separate because they move air through a duct. General light fixtures also have their own service when no fan is involved.
New Installation vs Replacement
Replacing an existing ceiling fan may allow reuse of a suitable fan-rated box and existing wiring, while adding a fan where only a light fixture existed requires verification that the support is appropriate for the weight and movement of a fan.
A completely new location can involve new wiring and structural support. That broader electrical scope should be confirmed rather than assumed as part of every fan installation.
Fan-Rated Box and Ceiling Conditions
Ceiling fans create dynamic load as the blades rotate, so the support must be intended for fan use. A standard light-duty fixture box should not automatically be treated as suitable just because a light fixture was hanging there.
Sloped ceilings, high ceilings and decorative beams can also affect downrod length and mounting hardware. Photos of the ceiling and existing box location help define the project.
Wobble, Noise & Speed Problems
A fan that wobbles can be affected by loose mounting, blade alignment or a warped component. Clicking or rubbing may come from blade arms, light-kit parts or trim touching during rotation. Speed problems can involve controls or fan electronics.
The service request should describe when the symptom occurs without encouraging the homeowner to reach into a running fan. If the mount itself is loose, stop use until the condition is assessed.
Light Kits and Controls
Light kits, pull chains, remotes and compatible wall controls can be part of the fan system. Replacement controls need to match the fan design, especially where an integrated receiver or smart controller is used.
New wall wiring or incompatible dimmer replacement can become electrical work beyond ordinary fan assembly. Confirm that scope before treating the project as a simple control swap.
FAQ
Can a light-fixture box always support a fan?
No. Fan-rated support should be verified.
Does this include new wiring to a fresh location?
New permanent wiring is separate electrical scope.
Can wobble be repaired?
It may be repairable depending on mount, blades and fan condition.